Saabscene Saab Forum - Saab Technical Information Resource banner

1 - 7 of 7 Posts

·
Registered
Joined
·
403 Posts
Discussion Starter #1
Hi all,

Has anyone else who has gone the brembo grey iron disc's and DS2500 route,suffer fron occasional squeeking at low speeds ?

I did use a small amount of copper grease on the contact surfaces but maybe I need more.

Any thoughts / comments

Ta

Damo
 

·
Registered
Joined
·
1,676 Posts
Don't know about the 2500's but the 3000's do squeal very noticeably on light application and I was told as much when I bought them. Personally, I don't mind given the brake performance on offer...
 

·
Registered
Joined
·
403 Posts
Discussion Starter #4
Ok Thanks - That saves me pulling them all apart again - i did service the calipers when i did the brakes and didnt think that i could have missed anything.

Cheers

Damo
 

·
Registered
Joined
·
1,086 Posts
My Hawk HPS pads and Brembo rotors squeak on light application as well. Provided there is no noise on moderate to heavy application, there is no problem if they are sqeaking on light application. Mine usually gets worse as the brakes get dirtier between car washings.
 
1 - 7 of 7 Posts
Top