Saabscene Saab Forum - Saab Technical Information Resource banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,411 Posts
Discussion Starter · #1 ·
I've got a JR filter sitting here (round, for a '97 CSE)

I've found where the old filter is, unclipped the three clips that hold the cover on ... and there's not enough clearance to get the old one out without forcing it, and doing that for the new one would probably damage it. The cover and pipe it's attached to get in the way,

So, what trick am I missing? What else do I need to do to get this new filter on?
 

·
Registered
Joined
·
1,411 Posts
Discussion Starter · #2 ·
Never mind. An application of BFI fixed it.

It's a good job the JR one is a tad smaller, though.

I take it I just need to put the filter in there? There didn't seem to be anything to fasten (other than putting the cover back on, of course).

[Edit: Of course, this is all explained on saab.info, but despite searching I didn't find this until afterwards
http://www.saabs.info/performance_saab/p...rionic_upgrade/

Words for the next poor mug trying to search procedure replace air filter ]
P.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top