Saabscene Saab Forum - Saab Technical Information Resource banner
1 - 6 of 6 Posts

·
Registered
Joined
·
496 Posts
Discussion Starter · #1 ·
Ok....so while my friend and I started to attempt to get the flywheel and clutch on before te rain picked up again....we put the flywheel "back together" the inner "like pilot bearing" thinggy...as seen in pics below. When i got it back from machine shop it was taken out, and neither of us can remember how it SHOULD go... and the service manual is rather bad on the help aspect. SOOOO I'm asking you fellas if ya could help us...is it in backwards? (and where do i get an anignment tool if SACHS shortchanged me and didn't send me one with my kit?) THX




Hope those pics work....
 

·
Registered
Joined
·
14,305 Posts
Perhaps not... but you only allowed 5 hours, and most of the board subscribers will have been in bed then- y'know a small time difference problem...


BTW, bumping contravenes the AUP...
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top