Saabscene Saab Forum - Saab Technical Information Resource banner

1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hey, so I'm finishing the total front end and subframe bushing replacement and I missed the WIS part of "mark the position of the subframe'...and..."motor mounts to center the engine". The mount notes are made for the Left (which I haven't touched) and the Right (which I removed to replace the serpentine belt).
How do that at this point?
Also, the gearbox torque arm is supposed to have the square rubber bushing 'centered', but to do that I have to pry the drivetrain aft about 1/2 of an inch. Is this correct?
Thanx in advance to the more experienced here.
Rick
 
1 - 1 of 1 Posts
Top