Search Results for ‘z19dtr’

As above looking to replace a flywheel and clutch and have the chance of one from a z19dtr. car had only done a 100 mile when it blew up.

Hi All, looking for a bit of advice if someone can help..... I have a 9-3 2008 model 1.9 ttid which I bought a couple of weeks ago. I bought it knowing it was sooted up probably about as bad as it gets but being a ex merc mechanic for 15 years I thought it would be a nice car once I'd delt...

Nice if you have money to blow - http://www.kcperformance.eu/en/tuning-by-engine/article/5.html

for sale ttid z19dtr bits crank in 100% great shape conrods in great shape pistons are marked due to it swallowing all flaps and a turbo but will go again block in good condition on ebay for 250 for crank 400 for pistons and conrods each conrod from saab is 400 and a piston 100...

cylinder head fully reconditioned z19dtr a19dtr a20dth a20dtr or z19dth z19dt upgrade head cleaned skimmed lapped with new seals £400 plus post ready to go

GENUINE BOSCH UPGRADE INJECTORS FOR SALE As you know uprated nozzled injectors are 700-800 quid on an exchange basis the nozzles are crap and the spray pattern no way near as good as oem spec as the tolerances are no where near as fine, meaning rougher running at certain rev ranges and...

after a full bottom end for a ttid for a build.... everything head down.... so crank, cons, pistons and block.... preferably with lower ancillaries also but not a necessity :) cheers

Can anyone with access to the Saab workshop manual please post a picture of the EGR valve and Exhaust system for the 93 TTID z19dtr engine.

In this guide I will attempt to help anyone who needs to remove their EGR valve on a TTID 93 Z19DTR engine. This was easy for me as a non mechanic and took approx 15 minutes to take off and replace. What you'll need Torque Set and Ratchet Size 30 Wynn’s EGR Cleaner Optional New EGR Valve...

In this guide I will attempt to help anyone who needs to remove their EGR valve on a TTID 93 Z19DTR engine. This was easy for me as a non mechanic and took approx 15 minutes to take off and replace. What you'll need Torque Set and Ratchet Size 30 Wynn’s EGR Cleaner Optional New EGR Valve...

Can anybody point me in the direction of the breather hose on the Z19DTR engine? I thought it was the metal pipe that snakes its way over the top of the engine but it comes from the bottom of one side to the bottom of the other? Any help appreciated Rob

Is it possible to remove and clean the egr valve on the DTR engine. I have looked at the WIS but can find on for this engine. Read somewhere else it's part of the cooler. Does this mean it's an improved part and shouldn't block? If there is one can it be bypassed with ECU mapping? Cheers Scott