does anyone know what size torx head ill need to get the front door panels off? I cant get them with an allen wrench

Hi to all ,first my car details 2005 9-3 tid(150) auto 16 valve 4 door saloon . I had my front disc's and pads replaced today and one of the torx bolts which holds the brake caliper to the hub needs replacing. could any one give me the dimensions of that bolt, as the biggest torx i have is a e18...

Hi All, Can anyone tell me the correct size Torx bit i need to remove the flywheel from a 1.9 DTH engine pls?

i was going to get a torx set for the saab aero 93 so i could do my own spark plug change and air filters etc. was looking at a set for T5 to T20 would this cover the engine bay. are the ngk the best plugs to get thanks

I assume the big end caps are held on by torx type bolts, does anyone know the size? or what they are if not torx thanks Paul

Hi Just wondering if anyone her can help me. Being in a flat with no room for tools My ignition coil pack has blown.It is the red one I need to know the Torx Key size to remove it and also if anyone has any prference of sparkplug socket size Long reach etc. I only ask because i need to get it...

Just fitted a replacement wing on my 9000CSE, I realise that one tool I'm missing is a T27 Torx screwdriver OR a T27 bit to fit a 1/4" driver. Does anyone know where I can get such a driver or set of large torx drivers?

Desperately worried I'm about to destroy the gearbox. What is this long bolt...? Haynes blanks out here - I foolishly thought this was a level port - because I hadn't found the filler port and misread manual gearbox references to filling to the level port. Now I've changed the setting on...

What size of TORX socket do I need for the head bolts? E?? Also what size for the Cam Cover screws? T?? Thanks Dave

What size of TORX socket do I need for the head bolts? E?? Also what size for the Cam Cover screws? T?? Thanks Dave

Hi, does anyone know the size of the torx key/bit required to remove the radius arm from the lower suspension arm in a 1996 NG900 2.0i Auto? Thanks. Colin

After lifting up the passenger side rear seat, I found this torx bolt and spacer. I looked around to see if I could find their home, but without success. Anyone know where they might belong? I couldn't figure out how to get the image to show up here using msn, but you can get to it by...

After lifting up the passenger side rear seat, I found this torx bolt and spacer. I looked around to see if I could find their home, but without success. Anyone know where they might belong? I couldn't figure out how to get the image to show up here using msn, but you can get to it by...

Does anyone have any tips on how to do this? Finally got round to replacing the locking actuators - went ok on the back door, but I can't remove the torx screws from the front door grab handle, they seem to be too worn.

Does anyone have any tips on how to do this? Finally got round to replacing the locking actuators - went ok on the back door, but I can't remove the torx screws from the front door grab handle, they seem to be too worn.

For those of you needing a small "glovebox" tool kit I found this in Halfords recently. A set of Torx drivers in a folding set T9 - T40:

to the balance shaft sprockets and the timing chain cover on a 9000 CSE '94 LPT model?

to the balance shaft sprockets and the timing chain cover on a 9000 CSE '94 LPT model?