Search Results for ‘seals’

looking for rear bonnet spoiler seals. to outside seals to bolt threads. middle fitting one nut fitting.. I have asked about been told £8.99 plus each. cheers all.

saab 93, 2.2 tid 2003 vector gave the car a service an noticed the fuel filter was black, when idling car was a bit smokey ( blue ) an was hard to start after googling i found injector seals give bother as do the leak off pipes so yesterday i sat about sorting that After building up...

Really struggling to find replacement rubber door seal things for 2001 Saab 9-3 convertible - I think these are called door aperture seals? Grateful for any help - if I at least had a part number the search might be easier.

Hi all My saab has a cold start problem - long cranking to start when the fuel tank is less than 3/4 full. After reading the forums, it sounds like this is a common problem with the injector seals leaking, allowing the fuel to drain back to the tank ? My question is this - if I fit a low...

Hi everybody I have a Saab 9-3, 2.2 TID 2002. It has the classic stating problem, reading the post's on the forums it sounds like the injector seals have gone and this is letting the fuel drain back to the tank. My question is this - if I fit a low pressure electric fuel pump in line, to prime...

Have my 2007 Vector Anniversary 9-3 auto for around 8 months and 15,000 miles now, and I reckon I'm getting to know the old thing. Something I've noticed is that when washed, or after heavy rain, there's a fair bit of water finds it's way past the outer door seals to sit and dribble around the...

If I open the valve cover for restauration do I have to definitely renew the present valve cover seals (1 outer and 1 inner)?? Thanks for your advice. Bill

Hi guys. The back window rubber seals on my 8 year 9-3 are peeling off, as a result of extremely hot summers and cold winters without a garage. At this point I can already see bits of metal exposed, but without leaks of any kind. Both my dealer and an independent dealer suggested me to...

Hi, I have 2002 9-3 (2.0 SE LPT) that was serviced last week. The oil pressure switch was replaced due to a leak. With less than 50Km on the car after I had a major oil leak. The car was towed back to the garage and now I'm told that both the front and rear crank seals are leaking and need to...

Hi All, can anyone tell me the procedure for removing the hydraulic cylinders that operate the soft top on a '99 model? I want to fit new seals / cylinders, and would like some guidance on the best way to strip the assembly.

Hi, Can anybody give advice/help on how easy it is to replace what I think is a leaky injector seal. I am not experiencing any loss of power or engine warning lights, however I have noticed an unburnt diesel smell entering the cabin. Also on tickover I'm getting a loud put put put put noise...

I have noticed that the seals below the front windows and the large one on the front of the top are getting rather brittle looking. I assume this is common but they are probably long out of production. Does any one know of pattern replacements or any way of preserving the rubber? John

I have a 1995 Saab 900SE Turbo convertible, which is leaking water through the top of both front windows - only a few drops whilst sitting still, but when driving in heavy rain we'll get a steady stream of drips beading along the top edge of the window seal and dripping down. There's also a...

A hole has devloped in the 'inner' door seal on the drivers side where it has been rubbed over the years, getting in and out. Is it correct that both offside & nearside seals are the same? The thinking being that if I can got hold of good used nearside one I can use that. cheers tim

My 1993 Saab 9000 has developed a water leak on the off-side rear door. So far as I can see none of the rubbers have perished. Any ideas as to a solution please?

does anyone know how much its going to cost to get the weather seals replayced? its only light dripping at the top of the door near the windscreen both drivers and passenger sides but its enough to keep me up at night. thanks chris

Well, I've noticed the noise of the turbo spooling up over the past few weeks, whereas before I hadn't noticed it at all. Now on the commute to work, I spotted some white/grey smoke out of the exhaust, which I last experienced on my MK1 9000. Thought it was the turbo and by the end of the...

Have finally decided to replace the door seals on our 95. Any words of wisdom from other members, or things to watch out for? Thanks

Constantly having cold start problems which I'm sure is caused by fuel draining back. Replaced the rubber return pipes and t-pieces this week, even going as far as to add fuel resistant silicone to each join to maintain the seal, but if anything its got worse! Not sure how its managed to get...

The drivers door seal is starting to fray on the back part of the seal (by the door pillar) caused by me getting in and out of the car I think. How hard is it to replace them and what sort of costs am I looking at? Or does anyone have any sneaky repair tips?