Search Results for ‘replace’

I have just replaced the the low beam headlight bulbs in my 2006 9-3 vert. The bulbs fit into the holes properly, and the clips seat in the notches and hold the bulbs securely. The problem happens when I try to reseat the ballasts. I can press them into place, with the four "legs" seating...

Hi everyone, My 2005 saab 93 1.9 tid vector sport aero needs the common swirl flap problem sorting! I am undecided which method to sort it, so would appreciate any opinions/advice. My car has about 111000 miles on it ( only do about 1300 miles per year, stop/start driving, getting 48 to 50...

Hi Guys, I hope someone can give a bit of advice. A few of the bulbs have gone on some of the switches, such as the rear wiper switch, hazard lights etc, plus I want to upgrade them to LEDs as they will be brighter. I'm looking for a way to crack them open without doing permanent damage to...

hi i am going to replace the interior on my 55 plate convertable , all seats plus door panels /cards and rear panels just wanted to know if anybody has done this and is it reasonably easy ,saab independent wants £300 to do it ,also need to swap the seat belts over as new seats have no belts...

Read more about Replace These 5 Parts for Better Mileage.

:)

Hi guys, I've got a 2002 2.2tid with what I suspect is a worn oil pump. Have changed the sensor, with no luck, and am pretty sure its the pump as you can hear the engine quieten when the oil light goes out. Question is is it possible to replace the oil pump with the engine in, take off the...

Quick Question - My Swirl Flaps have just snapped for the 2nd time in 4 years - go figure. And so I'm wondering - Do I..... a) Replace the inlet manifold AGAIN! at a cost of £170 and my time or b) Do what Ive been meaning to do for a while - i.e. Remove some of the guts from the DPF (as...

Hello All Is it possible to replace the clarion in my 94 with the Harman Kardon units found in later models? Are there any instructions on how to complete this project?Is it possible to purchase a wiring harness for the Harman Kardon system? Thank you Grant

Hey everyone, it's Trevor. As the owner of a 'classic' '93 Saab 900, I know that finding parts is challenging, to say the least. So whenever I come across some info. that may be useful...to anyone, I like to share it with others. This past weekend, I was searching online for auto parts...

Friday Mr Clutch finally done with D.M.F and clutch kit on my 9-3 ss Vector, after 2 day working and 350 quid only for replace. Neobros make me happy with my new clutch but i have a problem with turbo, dont work, no pressure. No code and i check all the vac pipes. Many thanks dear friends...

Hello I have 2007 9-3 Aero with a sliding armrest that has managed to slide all the way off its mount. The sliding mechanism is stuffed so I want to look at replacing the armrest. Does anyone know how you remove the armrest from the centre console? I've seen posts elsewhere that suggest it can...

I have a 9 5 auto 2004. In the centre console at base of gear lever there is a ribbed plastic slider that covers the hole for the gear lever movement. That slider has broken off rear of the gear lever, giving view into the workings and unatractive. I did cut a piece of rubber sheet to size...

Hi all, I need to replace my instrument cluster (rev gauge, speedo etc) as the Rev gauge is reading 1000rpm above what it actually is and the plastic front screen is cracked. I have found out that the replacement needs to be "married" to the car, so was wondering if anyone has dismantled the...

I've noticed over the past week or two that my clutch has started to slip (Arghh), it has a Stage 1 Noobtune remap currently, but I think it's already on it's second clutch in 98k miles?!? Will need to check the history again. Anyhow, I quite like the idea of taking it to stage 3 ish in the...

Is this actually feasible? Am planning on retrofitting at least one seat..... I. Find the heat wonderful fer my dickky back

Hello Everyone, I am going to replace the head bolts this week-end and correct me on this. 1. loosen the radiator cap before I start. 2. do one bolt at a time 40 nm, 90nm and 1/4 turn. Seems easy enough, I'll also be replacing the valve cover gasket and sparkplugs as well. It's a '95 9k CS with...

First Saab -Really like it :)New to the saab world, I really like the car. I definitely like working on it. Upper Marlboro, MD Prince Georges County, USA 2002 Saab 9-5 2.3t About 10 months ago I picked up a used 2002 Saab 9-5 2.3t. Check engine light came on, and engine was stalling...

Hi So considering swapping out the engine ECU with another to rule out a failing engine ECU. I know how to do this on a Vauxhall Vectra...but whats different on a Saab in terms of programming it / pairing it to the car etc?

So I need to replace the alternator in my 2006 aero and WIS call for removing the intermediate driveshaft to gain access to the alternator. Now I don't have the brass punch needed to "punch" the shaft out and I don't really know if I'll be able to put it back in (any tips on that?) so I'm...