Search Results for ‘polyurethane’

Has anyone tried the blue polyeurathane sport torque rod replacements? They come in two sections and seem to nicely made and easy enough to put in. They use your original alloy casting and are cheap. Has anyone had any experience of these? My Linear's (auto) torque rod has collapsed completely...

Calling all who have replaced rear ARB bushes with Superflex polyurethane...: Please can you advise how long Superflex (or similar) rear ARB bushes are typicall expected to last? I can hardly believe that they can fail an MOT for being too much movement after only 3 years and 20k miles...

hi , does anyone know where i can get a full set of Polyurethane Suspension Bushes for my saab 9-3 aero on a 51reg thanks daniel

Hi, Im curious what the difference is between the various polyurethane bushing manufactures is... Ive seen them on abbott, and elkparts has at least 3 manufactures listed. They all have different prices, (and i understand that some come with housing or the inner tubes) but regardless i think...

Due to a slight knock felt through the steering wheel when setting off I had a look at the front suspension arm bushes. When the steering wheel is moved, the arms move a few mm in the rubber bushes. I can not imagine they are meant to be like this so they must need replacing. I also noticed the...

I am looking into ordering some Powerflex bushes for my 9-5. The dealer gave me a quote and i figured that if i were to order all the bushes for the whole suspension, it would cost quite a bit. Can anyone give any advise as to which bushes shld i change to have the greatest benefit? i.e The roll...

Has anyone replaced the front butterfly bushes with polyurethane bushes? I note these are supplied as bushes only with no aluminum surround and have to be inserted into the existing aluminum piece. Has anyone done this and are any special tools required. I've changed the complete bushes before...

Has anyone replaced the front butterfly bushes with polyurethane bushes? I note these are supplied as bushes only with no aluminum surround and have to be inserted into the existing aluminum piece. Has anyone done this and are any special tools required. I've changed the complete bushes before...

I have a ropey but useable 900T8. Have done the ball joints, wheel bearings and track rod ends but still have a clunking from the right front. My guess is that the anti roll bar bush is dead. I think I'll do the outer pair as the next bit of work but as a genuine novice want some advice on...