Saabscene Saab Forum - Saab Technical Information Resource banner
filament
1-7 of 8 Results
  1. Classic Saab 9-5 (1997 - 2009)
    Hi, Does anyone know where the headlamp filament sensor is located on my 2005 9-5 2.2TID Estate? I have an intermittent main beam failure on the left side only. It only fails when cold. After driving around for an hour or so it works fine. I have replaced the bulb, and checked the fuses (all...
  2. Saab 9000 (1984 - 1998)
    The left front dipped beam lamp has no +12 power any more. Oddly the fuse blew a few weeks ago but all was well after it was replaced. Then the bulb failed. Something is going on with it. There is +12V on the bulb side of the fuse. That goes to a yellow wire that disappears into the wiring...
  3. Classic Saab 9-5 (1997 - 2009)
    T-reg 3.2T saloon On my 900 I had a problem with a double sized relay that switched the headlights and detected filament failure. I had some odd behaviour on my 9-5 which suggests the unit may be on the way out. I've looked in the engine fuse box, but can't see one in there. Where are they...
  4. Saab 9000 (1984 - 1998)
    Hi from a new kid on the forum - but a long time 9000 driver (87 9000 2.0i, 91 9000 2.0i, 93 9000 Aero, 97 9000 CSE 2.3T - now with 180K). Brake light filament monitor is on continuously and none of the stop lights work. Since simultaneous failure of all bulbs is unlikely, I am guessing the...
  5. Saab 9000 (1984 - 1998)
    Hi Folks, I've got a MY96 CSE with pictogram showing rear light failure and a non functioning high level brake light, the bulbs are OK and it seems that no 12v is getting to the fitting. A look at the wiring diagram recently linked to ( http://faq.saabnet.ru/_9000/electro-schemes/1997/...
  6. Saab 9000 (1984 - 1998)
    You may remember, I re-soldered the connections of the pins to the pcb last week. I was pleased with the result, until last night, when I found that the problem had returned. Pictogram displaying red headlights when the main beam was activated by the stalk & only the off-side main beam working...
  7. Classic Saab 900 (1979 - 1993)
    Hi there : I've discovered that the fine mesh filament on my Lucas FI air mass meter is damaged . It's the grid type rather than a single strand and is a little bent and has broken away from the casing in one place . Should I be worried - replace this item? (my breaker wants 100 quid...
1-7 of 8 Results
Top