Hi, I have an aero ttid 2008. I told my mechanic that I will install an aftermarket radio in my car and he said that he will not be able to run diagnostics on the car without removing the aftermarket radio (and temporarily replacing with factory one during the read). After seeing all the...

has anybody found where to get diagnostic software for this model 2011 9-5 ttid4 xwd. reason being, my motor was serviced recently and the service due warning came on then it went into limp mode. i purchased this car on halloween and it was fully serviced before i took it away from the garage...

Hey folks. could someone clarify the location of the data link connector on a 9-3 ttid 180 as im going to view one today and want to check for eml's etc. thanks..:)

Hi all I have a SAAB 95 2.2TiD 2003 model and have some issue with the turbo not working intermitently. sometimes it works for short periods but then drops out, Engine management light is on permanantly car does not go over 3000 revs when in this condition. this happened when i first bought the...

could some one please tell me where the diagnostic connection is on my 2004 9-3 aero this is a uk right hand drive model. thanks in advance.

bought a saab 9-5 diesel had two weeks and engine light has come on starting and running fine no over heating no limp mode ,light just on ?. has any one use one of the diagnostic software you can put on you pc and connect to your car and if so any good and where best place to buy from, any help...

Can anyone recommend a good diagnostic reader or one of those devices that reads all sensors on the car whilst driving, not too expensive thanks

Hi all, Please excuse the long message :) . I am looking for some info on the diagnostic connector in my car, recently I have got the CEL coming on. After checking up on reading flash codes from the car, I found that I wasnt able to get the car into a mode where it flashed the fault code. The...

Hi Guys, After spending a few days downloading various different types of Software, I wondered what everyone (or anyone) used on here at home. PC based of course. I'm looking at buying a USB-OBDII cable to try various softwares out and wanted to ask if there was anyone on here familiar with...

Is it the OBD 2 that saab use i was looking at getting a diagnostic kit has anyone got any recomendations thanks

Morning, I have a usb to odb2 connector so was wondering if there is any free software you can get to check fault codes from my laptop? This has no relation to my other post about the airbag light as I am just looking for some diagnostic software. Many thanks Jon

Morning, After recently changing my interior I have an airbag warning light on my dash. I tried plugging a geniscan gs400 in last night but it didnt want to read any fault codes? I also have a usb to odb2 connector so was wondering if there is any free software you can get to check fault...

I have read the 'pinned' topic relevant to fault codes, etc. but I am confused. My car is a 1992 9000 2.3I B234 Auto, non turbo. As I understand it, The 'pinned' topic says it has Bosch LH 2.4.2 Jetronic. The given locations for the diag socket are not where mine seem to be. I have a black...

Hi, I have lost power to my diagnostic port on my 1993 c900 convertible. Is it protected by a fuse - is there something else I could check? Incidentally what is the socket on the passenger side under the rear set (equivalent position to the diagnostic port) for? It has a connector plugged into...

Hi all, I guess there is a string for this: The Issue is simple. Where can I get a Plug to check my car and reset warning lights connecting through RS232C or USB ports on my laptopt, using of course the apropiate software. Tho connectors are under the seat, there are two with different colors...

Hi I have a copy of Sasb WIS program and want to connect my laptop up to the car so i can use the diagnostic section on it. What cable do i need to do this? The car is a 2.2 turbo Diesel liner 2003 reg. Cheers Rob

Hey Guys, I`ve found 2 ODB-II / CAN-BUS readers recently that say they support SAAB's. I know that standard OBD-II interfaces don't work on 1998 model like I have but these apparently support the CAN-BUS which if memory serves, is what the SAAB has...

Please can anybody help I have a 19993 Saab 9000CSE, and need help to locate the diagnostic plug I have been told that it may be under the front seat or under the dash, but we been unable to locate it, I would be most grateful for any help