Saabscene Saab Forum - Saab Technical Information Resource banner
circuit
1-20 of 34 Results
  1. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    Hi guys I have a saab 93 auto 2009 diesel with fault codes for rad fan relays 1 2 3 open circuit fans work with power probe replaced relay pack I have a seven pin block connector on fan I have two earth two lives and 3 control wires all earth and lives ok on the the 3 other wires I have 3.5 v...
  2. Saab 9000 (1984 - 1998)
    Saab 9000 Aero, 1994, 2.3 Turbo Parked car for 3 weeks while out of town. Everything had been working fine. Tried to start, battery almost completely dead, starter did not even click. Charged battery (it's relatively new) and it took full charge. Put battery back in car, as soon as i connected...
  3. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    saab 9-3 1.9 tdi 150 bhp anyone have any ideas what this means? and where and how i can rectify it many thanks john
  4. Classic Saab 9-3/GM900 (1994 - 2002)/Conv ( -2003)
    this is an update to my daughters 2001 saa 93 2.0 turbo, she has been riding it without the maf plugged and its been driving fine, then last night it would not start. it appears to want to start but wont turn over, the code that comes up is the 0743 but no mechanic or transmission expert knows...
  5. Classic Saab 9-5 (1997 - 2009)
    Hello all, Finally got around to buying and OBD 2 reader for this damn re-occuring flictuating revs prob. Chsanged all plugs, D I Pack, front gen Lambda, cleraned maf,all hoses NOW ok, and yet the warn9ing light keeps coming on and the obd is displaying P0101. as you can see from pic it's not...
  6. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    I recently changed the MAP sensor on my a couple of weeks ago as I broke the old one when replacing it. The engine management light is on and my car is coming up with P0105 MAP sensor and P2226 Barometric pressure circuit. In an attempt to see if the sensor is working properly, can anyone advise...
  7. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    (intro, skip this paragraph for post) Hi all im new here, obviously. I have an 04 9-3 linear and ive had it for roughly 7 months and i love it, all has been well except little stuff. But now i have an odd problem, my interior lights stopped working and i began to hear a clicking noise from my...
  8. Classic Saab 9-3/GM900 (1994 - 2002)/Conv ( -2003)
    Dear People, I found the above fault code and was wondering if anyone could explain exactly what it means and how bad it could be? Thanks
  9. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    Fault Code read via VS550 - is this a replace the glow plugs code? Car is on original plugs and completed 180K (relatively trouble free - touch wood!!!) TVM
  10. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    Is this the turbo bypass valve in question? also I saw a post by: ctrlz I believe it was on subcentral regarding the solenoid on the front of the engine, which could also be in question. http://www.saabcentral.com/forums/showthread.php?t=53614&highlight=bypass+plumbing what are some ways of...
  11. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    Posted this on another thread but thought I might have better luck starting a fresh one. Just had a new clutch fitted and car come back with CEL lit. Took car back to garage the get the codes pulled and found 1 code as follows. P0380 Glow Plug/Heater Circuit "A" Malfunction Me and the...
  12. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    I am still have some reception issue's with my radio and wondered if anybody had a circuit diagram for the rear side panel aerial on the 9-3 Sportwagon (2008 model). There must be amp somewhere for it. Thanks
  13. Saab 9000 (1984 - 1998)
    1997 9000 2.0 CSE LPT I am trying to sort out the ABS light (permanently on nowadays) so I started with checking the sensors. The front two read fine - around 1100 ohms each more or less when testing at the connectors in the aquarium . But doing the same method for each of the back pair at the...
  14. Help, Advice, Saabs and Motoring
    can any one please tell me what this means as now have this fault after having a new alternator and battery fitted fitted auto data says wiring short to earth,alternator a cording to what i can find online please help as just had this car given to me
  15. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    My 2005 93 1.9 tid 150 bhp has been comming up with "Stability Control Failure Contact Service", had this problem for about a month now and just managed to get my OP COM on the system resulting it the following fault: Identifier: 0x0301 Hardware number:12801327 System name: ESP EBC430 Part...
  16. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    Thats the fault thats coming up on code readers that aren't a Tech 2. Just wondering would a Tech 2 give more precise info and location on what the problem is ,because i've changed the glow plugs and there is nothing wrong with the relay. Mechanic says the problem is between the ecu and relay...
  17. Saab News
    Photo Credit: Etienne Morsa I have recently learned that as the auto season begins later this month in the United States, the all new Saab 9-5 that debuted last month in Frankfurt, will be added to the lineup. Below is the schedule of the auto show for the remainder of the year, which at this...
  18. Saab 9000 (1984 - 1998)
    i can not seem to find a wiring diagram on any of the threads posted my swedish matball was at 9 volts on the dash display when i mesured it with multi meter it was 11 volts at battery after jumping car the ecd or dash goes from 19.9 to 9 to 3 to 5 and so on i replaced the alternator as the old...
  19. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    thought I must have the dreaded EGR problem with lumpy running and no acceleration. Replace EGR but no improvement. Diagnostics gave me above error. Any clues? New injector needed? wiring? Car is a saab 9-3 1.9tid 150. 05 plate with 60k miles. Any suggestions gratefully received.... Bob
  20. Saab 9-3 Sedan/Combi/TurboX/AWD(2003+)/Conv(2004+)
    Hi there, my engine diag light has come on on my 9-3 1.9 Tdi (2005), the code being returned is "p0380 - Glowplug/heater ckt A malfunction". Engine starting does not seem to be compromised and the glowplug light goes out after a few seconds before i then turn the key to start it. Does anyone...
1-20 of 34 Results
Top