97 Reg modle does any one no the part number and if possible does a Vauxhall/GM part fit?

So that was some wise arse throwing a concrete based waste paper/litter bin (Street furniture) through my windscreen :mad: Was having a wee trip thro' the Blackpool Illuminations & we had a bit of a incident ....... JM got all physical & ran after the dude ...... I must admit I was having...

In my quest to replace my shot rear stops,the dielectric originals quite torn,I have come across these from this UK supplier.I have been unable to find vectra c stops which should fit but been advised some opel stops will fit. HAs anyone any experience of these or advice on if they will...

Guys/Gals, Really, really need your help, feeling a little low!! Driving home on the A1 today, I was unfortunate enough to drive over a rather large piece of metal, unfortunately the other lane was occupied, so avoidance was difficult. Luckily i managed to get piece in between the tyres, but...

hi all, just fitted new hirsch springs,and the ride is much better, but the rear bump stops are in asorry state, so are they a dealer part or can anyone tell me of a supplier. first impressions are good and well worth the effort. steve

just out and about on my travels when i pulled up at screwfix had my son in the car seen a space and started reversing my son started saying dad i feel sick i lost my concentration and bump the herb was infact a large concrete wall about 3feet high i couldnt believe it there were a few people...

hi does anyone know if the adr bodyshop in pontefract is any good? as the rotten local bus scraped alond my o/s/f door and 1/4 panel on saturday and that where the insurance say it is to go. Not a very happy chappie at the moment, i was in the paper shop at the time and the bus didn't even stop...

When going over bumps on the M-way my cruise disengages - stiff springs and shocks don't help. Is there any adjustment to the clutch and brake pedal to reduce the sensitivity or do I need new switches?

Hi, After the great help from my 'surging turbo' question. He's only other 'fault' i can find with the 97-Saab 9000-2.3 Turbo - P Reg of mine. When going slowly over a bump or hole I get a clunk or knock noise. It seems to only /mainly happen if steering wheel is turned to the right. Does this...

Went over a speed bump yesterday, very slowly I hasten to add, only to hear a great "clonk" when going down the other side. Had a quick look underneath but nothing obviously damaged. However, when we got home and I was unloading I noticed the floor area in front of the rear n/s seat has been...

Does anyone know what is the suitable bump stop size for front Koni sport shocks? Dimensions would be useful

I have the Saab standard phone-kit fitted with the bump on the passenger's side of the dashboard. It's always creaked when someone lent against it, but last week I had to climb out of the car via the passenger's side and managed to kick it off. The top clip (the one that's roughly s shaped) at...

Ooops Parking the car yesterday and forgot the 9-5 estate is much bigger than the old Volvo v40 I turned into a parking space and I bumped into the back of a Zafira. Ooops. The other car really bounced !! I did not feel anything inside the Saab - Very solid!! My wife said 'you would...

When driving over 30 mph say on a dual carriage way and I go over a pot hole or rough road the car seems to wobble from one side to the other then calm down. Any ideas??? The tyres are all fine.

Greetings! Does anyone know if the steering rack needs to be "bump steered" after lowering the car? I know that the Porsches needed to have their racks shimmed to bring the tierod ends closer to level. Thanks in advance as usual. Regards, John

Greetings! Does anyone know if the steering rack needs to be "bump steered" after lowering the car? I know that the Porsches needed to have their racks shimmed to bring the tierod ends closer to level. Thanks in advance as usual. Regards, John

This applies particularly to our American guests that have joined recently. DO NOT BUMP TOPICS Anyone bumping topics will have their posting rights frozen. Please be patient and wait for someone to answer your question - some people do not spend 25 hours a day at their computer

Damn and blast I've found a split bump stop on my nearside suspension coil. So, ho hum, I suppose I should get it replaced and I guess it can't be done without removing the coil (which means special tools which I haven't got). The first question is how much am I looking at? And the second...