Search Results for ‘access’

Hi I've recently joined Saab Scene in an attempt to resolve hot air blowing from the rear vent and I've found the following thread. 08 AirCon fault, Hot air thru rear vents At the beginning of this post it says that Photos are now in the Album Section. It also mentions a link to the relevant...

http://www.saabscene.com/forum/archive/index.php/t-199497.html? Above link is now in Archive, which does not seem to accept additions - hence "new" topic. I did mention 'markings' on the SAAB screwdriver, to aid removal of plastic retainer fittings on tailgate. I have now looked at the SAAB...

I have the wagon ('01) disassembled and can almost have access to removing and replacing the sub. But the onstar plug stands in the way of the removal on the dress panel and box that holds the onstar and covers the sub. Not the screw in plugs for the cell unit or the onstar unit below it. I...

Tailgate lock is now erratic. Started staying locked, regardless of using key fob, door panel release, or manual key on tailgate. Then it all seems OK and normal - for a while. Trying the manual key on tailgate was very strange. Turn the key and noise sounds like unlocked OK, but within a second...

Turn signal stopped flashing. My Bentley manual doesn't give much info about the relay, saying only that it is under the instrument panel on the left side. The Manual tells how to remove the instrument panel up to '89 but not '91. Manual says 91's have a steering wheel airbag, but my Canadian...

Hi There Don't know if anyone can help? I have a 9-3ss convertible (2004) and both the front seats have stopped sliding when you lift the handle and tilt the seat so passengers can get in the back. Strangely this happened within days of each other which obvously isn't linked but does make...

Hi, I'm hoping to get easy access to the parking sensors on my MY07 9-3 Sportwagon. One of my two centre sensors has become unclipped and pushed in slightly. I had this with one of the outer ones, but it was easy enough to get my hand behind the bumper and clip it back in. But with the...

Hi there, The door lock is getting 'sticky' and lubing it externally doesn't help. If I remove the internal door trim, can I get access to the lock to lube it from within? If so, how do I go about removing the door trim? Cheers

Hi On a 1993MY 9000CS with no airbags, is it possible to access the main relay panel behine the fuses by taking the top of the dash off? The Haynes guide says that the glovebox has to be removed Many thanks Peter

I’m going to replace the bushes on the rear torque arms (with Superflex bushes), & once the job is done the final tightening of the torque arms obviously needs to be done with the wheels back on the ground. My question is… how do you access the bolts to do this once the cars back on terra firma...

Hi all, Still trying to track down my cold starting problems. I want to see if the intank primer pump is working, i want to check the connections to the pump and am hoping the electrical connections can be accessed from within the car. Anyone know where i might find these connections ?? Many...

Hi guys, We have a 9000CSE 2.3 lpt auto (therefore no glove box as the air bag is there instead) I'd appreciate some of your collective wisdom. Went to put the hazards on the other evening - twisty road - accident with Police cars blocking my side - dont want to be punted up the backside so...

I was checking into comments for the BSR-Turbo-X entry from earlier today and MarkoA mentioned Hirsch’s tuning for the 9-3 TTiD. I thought I’d lob on over to the Hirsch site and see if there were any details about it. Just in case. FYI, the TTiD tune is “coming soon” and is listed there at...

Hello! Last week, my wife's 9-3 Aero suffered a full central locking system failure. No response via either key, so we used the emergency procedure as stated within the owner's manual, to get into the car. However, we have a slight problem... How do we access the fuel cap? Looking at the...

Not sure how to explain this - if you have a Classic convertible, you'll know what I mean..... The job I need to do is this: check that all the screws holding the metal plate across the back and bottom of the hood are correctly inserted, and then I want to seal the holes from below to prevent...

Can anyone suggest where I can safely tap into an ignition live wire, and a lights + from behind the instrument panel? I want to fit an electronic boost/warning gauge which also has LED illumination so the power drain is not heavy. Even so, should I fit a fuse to each +ve line? With thanks...

Hi, Not posted for a LONG time (lost my password...) I have noticed a couple of tiny rust bubbles just ahead of the rear wheel arches on my 97 Aero. I had a play removing carpet, seatbelt anchors etc to find a means of getting a waxoyl lance in there, but with no luck. Any ideas? Ta, Zip...